Due to their fiber-reinforced and homogeneous structure, gypsum fiber boards can be processed very well, even without special tools. They can be easily cut to size and fastened with commercially available means such as screws or clamps.
The properties of plasterboard for indoor use
In addition to plasterboard, gypsum fiber boards are the most frequently used wall cladding in interior construction. The panels consist of easy-to-work fibers made of plaster of paris and cellulose and are ideal for covering walls and ceilings. They offer positive properties and easy processing:
- Also read - This is how gypsum fiber boards can be easily cut and processed
- Also read - Gypsum fiber boards are easy to process and level
- Also read - properly plastering gypsum fiber boards after priming
- The materials are not flammable.
- They can also be installed in damp rooms without any problems.
- The panels are suitable as a substructure or as cladding in the roof or wall area.
- They have a very high mechanical stability.
- It is even possible to build partitions made of plasterboard, as they are very robust.
For processing gypsum fiber boards indoors
The materials should be processed at an average humidity of less than 80 percent, and the room temperature should not be less than five degrees Celsius, and when gluing the panels, not less than ten degrees Celsius. Make sure that the panels have adapted to the surrounding room climate. The processing of the gypsum fiber boards is quite unproblematic, so that you do not even need special tools. The panels can be cut by scratching the panels with a small knife and breaking off one edge. Alternatively, you can use a jigsaw for cutting, for example to make holes for installations.
So you can fix the panels in the desired places
The panels are simply screwed to a wooden substructure using suitable screws. There are even special drywall screws. If you use these, you don't even have to pre-drill the holes. You should not use any other screws either. Most gypsum fiber boards can be screwed or clamped to the edge up to about ten millimeters without any problems. In doing so, however, you should adhere to the minimum and maximum distances between the screws or brackets, which are specified by the manufacturer of the panels. The best way to grout the panels is to use a joint filler, such as can be used for gypsum fiber panels. Filling is usually carried out in two steps (pre-filling and subsequent or subsequent filling). Fine filling).