Oil the wooden floor in 3 steps

You can also seal a wooden floor with oil afterwards. You can even oil a lacquered floor after renovation. A new paint does not always have to be applied. However, solid, comprehensive preparatory work is necessary for this. How you can oil or re-oil a wooden floor is shown here in the instructions.

Elegant wooden floor

You can also achieve a slight color change with a wood oil. First and foremost, however, the wooden floor is becoming more elegant. However, if you want to use a colored wood oil, then you should be quick to oil it.

  • Also read - waxing wooden floors in 3 easy steps
  • Also read - wooden floors - rather seal or oil?
  • Also read - Wooden floor: what types of wood are possible?

In a passageway, however, you should refrain from color-pigmented oil, because the color will disappear first in the tread. However, it is difficult to re-oil with pigmented oil, as the approaches would always be visible. So you would have to sand down the entire floor and re-oil it every time.

Coloring with wood oil

If you want to slightly change or enhance the color of the wood, you should definitely know what type of wood you have on the floor. Hard woods hardly take on the color of the oil, while some soft woods really soak up the pigments. If you want to achieve a stronger color change, you should use a leftover board from your floor as a test object. The result can hardly be corrected later on the floor.

Oil the wooden floor step by step

  • Wood oil
  • Brush / paint roller
  • Grinder / floor grinder
  • Various grain sizes of sandpaper
  • soft towels
  • coarse brush
  • vacuum cleaner

1. grind

The most important thing when refurbishing a wooden floor is always sanding. Even if it seems tedious, do not try to shorten this work. If the floor is badly scratched, consider starting with a 40 grit and then working your way up to the 60 and 100 grit. In between, the sanding dust should be picked up with a fine broom or vacuum cleaner.

If the wood has not been used heavily, it is sufficient to start with the 60 grit. Depending on how fine you want to sand the wood, you should finally re-sand it with a 120 grit. The floor is even finer with a grain size of 150, but such a fine surface is usually not necessary for an oiled floor.

2. Clean

The floor must be cleaned thoroughly not only in between, but also at the end. Of course, there must be no moisture involved. The sanding dust must be removed thoroughly, otherwise you will work it in.

3. Oil

Apply the oil sparingly with a painter's roller or a wide brush. After the oil has absorbed, you should apply a second layer of oil. The excess can be removed with soft cotton cloths after a reaction time of about half an hour. For many floor grinders there are also the corresponding polishing pads that make this work much easier.

Tips & Tricks Borrow a floor grinder from a hardware store. Not only does this save a lot of work, but the floor becomes more even than if you sand it over with a small do-it-yourself machine. The sanding pad of the large machines rotates evenly and always exerts the same pressure when sanding.

With an orbital sander (€ 24.90 at Amazon *) or an eccentric sander, however, you would sand differently everywhere and, in the worst case, even sand new tracks into the floor.