Drive in wooden posts - you should pay attention to that

It sounds so easy, just drive a few posts into the ground. But there is a lot that can be done wrong with this little piece of work that cannot be straightened out again. The wood must be protected before it is cut into the ground. Also, you should never hit the exposed top of the post.

Important tips for driving wooden posts

For example, it is important to protect the top of the post from the blows of the sledgehammer. There are various methods of doing this, such as a laid board or an empty can from the kitchen that fits over the post.

  • Also read - Fastening Wooden Posts - Various Methods
  • Also read - extend wooden posts - various fittings
  • Also Read - Fastening Wooden Posts to Concrete
  • put a board on top of the post
  • Put the tin can over the post
  • Pull the wire tightly around the post just below the end of the post

Save top of the post

Posts that are driven directly into the earth have a pointed tip. Nevertheless, wood is naturally much softer than stone. As a result, it is often difficult to drive a wooden post into gravelly terrain. If the area in which you have to drive in the wooden post is too stony or hard, you should first dig a small hole and then re-sludge the post with the stones, i.e. rinse it with water.

Protect instead of exchanging

Most posts that are sold as drive-in posts are pressure impregnated. However, it doesn't last forever either. If you want to make the fence posts really durable, you should put them in a tall bucket of wood preservative for one night. The wood then soaks up properly with the wood protection.

Tips & Tricks If you have to drive wooden posts in frequently, a post driver will help you. This has a kind of sleeve and two handles with which you not only hammer in the post much more easily, but also protect the head of the post. However, the post driver is not worthwhile for one-time use, because the tool is not very cheap and otherwise useless. For a post diameter of up to twelve centimeters, the hand ram costs around 70.00 euros. Smaller specimens are cheaper, but also only suitable for a few posts.